E-mail setupRecently updated — within the last 72 hours

It is possible to have the Behnke Station sending e-mails in certain situations. This configuration guide describes how to set up the e-mail feature.

1. E-mail setup

Open your browser
Access the web interface of the Behnke-Station
Log in

Behnke-Station, Login

Click on ---WIKI page_id: en-bs-menu-network

- Scroll to the section **E-mail** - Set the option **Allow sending e-mails** to **yes, via SMTP** or **yes, via SMTPS (SSL/TLS)** (depending on your mail server) - The required fields for login will be shown - Fill-in the fields with the information of your mail server - Press ---WIKI page_id: en-bs-menu-store-red ---

to save the configuration

Behnke-Station, Network, Email

You can test if you're configuration work
Click on the button send next to the option Test mail
An input mask appears in which you can enter an e-mail address for the receiver
Click the button OK to send the e-mail

Behnke-Station, Network, Test mail

The Behnke-Station will try to send an email
You should receive a feedback after a few seconds

2. FAQ

This section is still empty

---WIKI page_id: legal-notes

Was this page helpful?

If the procedures documented here do not work:

Make sure the latest firmware is installed on your Behnke-Station. The latest version is 6.33 and can be downloaded here.
Check the notes in the manual and in the manuals.

If none of the above tips help, open a new support ticket or contact our service hotline.

Last modified on October 14, 2026 (today)Edited byMoScMaH2 min read370 Views