Configuration guide: Behnke Station, camera and IP video software in the same IP address range
1. Configuring the IP video software
-
Start the configuration of the IP video software and enter the phone number that the Behnke Station is dialing when a button is pressed in the "Workstation-ID" field and then click on "Save configuration". The window with the video will only appear if the Behnke Station is dialing this exact number. The spelling of the number must correspond exactly to the number stored in the Behnke Station.
NOTE:If you do not know the number, please access the web interface of the Behnke Station. There you will find the phone numbers to be dialed by the Behnke Station in the menu on the left under "Buttons".
-
Then switch to the "IP door intercoms" tab in the IP video software. There you should see a black square with the IP address of your Behnke camera in the section on the left. The IP address of the Behnke Station should be listed in the box on the right.
NOTE:If neither the IP address of the Behnke Station nor the camera are listed here, please check whether you have set the exceptions for the IP video software in the Windows firewall. If only the IP address of the Behnke Station is listed, please add the camera manually. Manually adding a camera is described in the following configuration guide: Manually adding a camera
-
Then select the camera with a left click and enter the "password" for accessing the camera on the right (Admin by default). Then select the Behnke Station in the box on the right and click "Save Configuration" at the bottom. The camera will then be assigned to the Behnke Station and a corresponding entry will appear in the box below. After a few seconds, the camera preview should be displayed.
Basic configuration is now complete and the configuration window may be closed. A window with the video should now open automatically when a call is triggered at the Behnke Station. The window is displayed for the duration of the call. After hanging up, the window will close again.