Ask the wikiAI

Restarting the Behnke Station

This setup guide describes the different ways to restart the Behnke Station.

It is assumed that the Behnke-Station is already set up to the extent that access to the web interface is possible. If this is not the case, please follow the instructions provided with your base electronics (manualsThis page carries no version. This notice is generated automatically and was not written by an editor.) and refer to the technical manualRecently updated — within the last 72 hoursUpdatedThis page carries no version. This notice is generated automatically and was not written by an editor. to complete the basic setup.

1. Restart via the web interface

• Open your browser
• Go to the web interface of the Behnke Station
• Log in

• In the sidebar on the left, click the menu item System
• Navigate to the section that contains several buttons

• Look for the System option
• Click the Restart button
• Confirm the restart in the dialog
• The system restarts
• After 60-90 seconds, the system should be ready for operation again

2. Restart via the settings on the display (for Behnke indoor intercom station)

• Go to the monitor of your Behnke indoor intercom station
• Tap the gear icon in the bottom right corner
• You will be asked to enter the administrator password
• An overview page appears
• Select Settings of this device there
• From the next list, select the entry System
• Navigate to the entry Restart
• Confirm the restart in the dialog
• The system restarts
• After 60-90 seconds, the system should be ready for operation again

3. FAQ